Instructions / Assembly

7 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Operation
1
Adjusting the lamp heads
□ If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
2
Determining the motion sensor
detection zone
NOTE: The motion sensor (C) is non-adjustable. It has a
sensing angle of 180° and a range of approximately 40 ft.
depending on the surrounding temperature.
NOTE: The motion sensor (C) will need to completely
warm up (60 seconds) before beginning the setup process.
The light will only operate at night.
□ Perform a “walk test”: walk in an arc across
the front of the motion sensor (C).
□ Watch the light (B). The light (B) will come on
indicating motion has been detected.
□ Stop, wait for the light (B) to turn off, and then
begin walking again.
□ Continue this process until the detection zone
has been established.
□ If the desired area to be covered is not within
the detection zone, relocate the light (B) to
cover the desired area.
Care and Cleaning
□ To prolong the original appearance, clean the light xture with clear water and a soft, damp cloth only.
□ Do not use paints, solvents, or other chemicals on this light xture. They could cause a premature
deterioration of the nish. This is not a defect in the nish and will not be covered by the warranty.
□ Do not spray the light xture with a hose or power washer.
□ If not to be used for several weeks, turn the unit OFF.
C
B
A