Instructions / Assembly
7 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Installation (continued)
7
Caulking around the light
fixture
□ Caulk around the 1-2- asy Connect™ (C) and
mounting surface with silicone sealant (not
included).
8
Adjusting the lamp heads
WARNING: Risk of re. Keep the lamp heads at least
2in. (51mm) from combustible materials.
CAUTION: Keep lamp heads 30° below horizontal to
avoid water damage and electrical shock.
□ Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
□ If needed, gently grasp the lamp heads (A)
and tilt them up or down to adjust the light
coverage area.
NOTE: The lamp heads are designed to rotate up and
down only. Do not attempt to rotate any other direction.
Care and Cleaning
□ To prolong the original appearance, clean the light xture with clear water and a soft, damp cloth only.
□ Do not use paints, solvents, or other chemicals on this light xture. They could cause a premature
deterioration of the nish. This is not a defect in the nish and will not be covered by the warranty.
□ Do not spray the light xture with a hose or power washer.
Troubleshooting
Problem Possible Cause Solution
The light will not come on. □ The light switch is turned off. □ Turn the light switch on.
□ The fuse is blown or the circuit breaker
is turned off.
□ Replace the fuse or turn the
circuit breaker on.
□ The circuit wiring is incorrect (if this is
a new installation).
□ Verify the wiring is correct.
C
A