Instructions / Assembly

5 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Installation
1
Determining the mounting
location
□ Determine the mounting location – wall or eave
mount.
□ Position the lamp heads (A) in the general
direction of the desired light coverage.
Wall Mount
Eave Mount
2
Removing the 1-2- asy
Connect™
NOTE: This xture comes with a 1-2- asy Connect™ (C).
It is pre-assembled on the light xture (B) for shipping.
NOTE: The large mounting bolt (EE) is pre-installed in
the light xture (B). Do not attempt to remove the large
mounting bolt (EE).
□ Unscrew the large mounting bolt (EE) connecting
the light xture (B) to the 1-2- asy Connect™ (C)
and remove the 1-2- asy Connect™ (C).
NOTE: A rubber gasket is pre-installed in the
1-2- asy Connect™. Gasket is shown as black in
illustrations for clarity.
GND/Terre/Tierra
L (Black/Noir/Negro)
N (White/Blanc/Blanco)
UP/Haut/Arriba
3
Installing the mounting bracket
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light xture.
NOTE: Six mounting bracket screws of various sizes are
included. The installation will only require two. Discard the
unused mounting bracket screws after installation.
□ Remove the existing light xture.
□ Install the mounting bracket (GG) with the
stamped word “FRONT” facing away from the
junction box. Use the mounting bracket screws
(BB, CC, or DD) that best t the junction box.
□ Firmly pull on the mounting bracket to verify
it is securely mounted to the junction box. If
necessary, use the screws that were removed
from the existing light xture.
FRON T
FRONT
A
EE
C
B
BB, CC, or DD
GG