Instructions / Assembly

6
Installation
1
Drilling Canopy Holes
Ƒ Determine which of the knockouts need to be
drilled to match the mounting holes on the
junction box.
Ƒ Drill the necessary holes into the canopy using
a drill (not included) and a 3/16” (5 mm) drill
bit (not included).
2
Wiring the Light Fixture
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light xture.
CAUTION: Do not cut any wires with factory installed
wire connectors or remove the wire connectors.
Ƒ Remove the existing light xture.
Ƒ Route the light xture wires through the large
hole in the gasket (DD).
Ƒ Connect the light xture wires to the junction
box wires with wire connectors (AA):
Ƒ White to white
Ƒ Black to black
Ƒ Bare or green ground wire to house ground
3
Mounting the Light Fixture
Ƒ Align the drilled holes on the canopy (B) with
the holes on the junction box.
Ƒ Secure the canopy (B) to the junction box using
the mounting screws (BB or CC) that best t
the junction box. Do not overtighten.
NOTE: Make sure all the wires are inside the junction box
before attaching the canopy (B) to the junction box.
4
Caulking Around the Light
Fixture
Ƒ Caulk around the canopy (B) and mounting
surface with silicone sealant (not included).
B
B
B
BB or CC
DDAA
AA