Installation Guide

8
Operation (continued)
7
Using Manual Mode
Manual mode overrides the motion sensor (A) and
“ON-TIME” control so the light will operate full bright.
This feature only works at night and only for one night
at a time. The motion sensor (A) will reset to motion
sensing mode at sunrise. Manual mode can be toggled
on and off using a wall switch.
 To turn manual mode on, switch the light off
at the wall switch for 3 to 4 seconds and then
back on.
 To turn manual mode off, switch the light off
at the wall switch for 3 to 4 seconds and then
back on.
NOTE: If the power to the light xture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
Turn the switch
OFF for 3 to 4
seconds
Turn the
switch
back ON
Care and Cleaning
 To prolong the original appearance, clean with clear water and a soft, damp cloth only.
 Do not use paints, solvents, or other chemicals on this motion sensor. They could cause a premature
deterioration of the nish. This is not a defect in the nish and will not be covered by the warranty.
 Do not spray with a hose or power washer.