Installation Guide

6
Operation
1
Adjusting the Motion Sensor
CAUTION:
CAUTION:
CAUTION:
NOTICE:
2
Setting the Sensor for Testing
When the “ON-TIME” switch is set to the “TEST”
position, the light xture will operate during the day
or night. The light will stay on for 5 seconds after all
motion is stopped.
 Set the “ON-TIME” switch to the “TEST”
position.
 Set the “DUALBRITE” switch to the “OFF”
position.
 Turn the “RANGE” dial to the “MIN” position.
 Aim the motion sensor (A) in the general
direction of the area to be covered.
NOTE: The motion sensor will need to completely warm
up (90 seconds) before beginning the setup process.
ON-TIME DUAL BRITE
®
TEST 1 5 20
MINUTES
OFF 3 6 DUSK TO
HOUR DAWN
MAXMIN
RANGE
A
A
A
3
4