Installation Guide

5 HOMEDEPOT.com

Please contact 1-866-308-3976 for further assistance.

Installation

Installing the Motion Sensor

WARNING: Turn the power off at the circuit breaker or

fuse. Place tape over the circuit breaker switch and verify

power is off at the light xture.

The WHITE motion sensor wire is neutral. The BLACK

motion sensor wire is hot. The RED motion sensor wire

is switched “hot”.

 Remove the existing light xture.

 Route the motion sensor wires through the

canopy (1) of the existing light xture.

 Screw the motion sensor (A) into the

canopy(1) of the existing light xture.

Wiring the Motion Sensor

 Connect the motion sensor wires to the light

xture wires and the junction box wires with

wire connectors (AA):

 White to white

 Black motion sensor wire to black junction

box wire

 Red motion sensor wire to black bulb

holder (2) wires

 Bare or green ground wire to house ground

and any light xture ground wire or ground

screw, if present

 Follow the instructions that came with the

existing light xture to mount and adjust the

light xture.

Wires from Junction Box

Black

(L)

Ground

White

(N)

Red

(Load)