Installation Guide

Pre-Installation (continued)

HARDWARE INCLUDED

NOTE: Hardware shown to actual size.

Part Description Quantity

AA Wire connector 4

PACKAGE CONTENTS

Part Description Quantity

A Motion sensor 1

MOUNTING LOCATIONS

 Determine the mounting location – a wall or

under an eave.

 If needed, lift the motion sensor (A) up and

rotate it so the controls face the ground after

installation. Tighten the clamp screw when done.

Do not overtighten.

NOTE: If the motion sensor (A) pops out of the ball joint,

loosen the clamp screw, push the motion sensor (A) back

into the ball joint, and tighten the clamp screw. Do not

overtighten.

Wall Mount

Eave Mount