Product Manual

25
ALARM
Enable the DVR to detect motion, and adjust the motion detection settings.
MOTION
Channel: Set up automated alarms for the selected channel.
Enable: Enable/Disable the alarm on the channel.
Buzzer: Enable/Disable the DVRs internal buzzer. The buzzer will go off when motion is detected. The buzzer
length can be adjusted from the Events section of the Alarm Tab.
Sensitivity: Adjust the duration of the buzzer sound.
Area: Block areas from motion detection. This is used to remove an object that has constant motion from the
camera field of motion detection. This area will still show in the recorded footage.
Post Recording: The duration in seconds that the DVR will record when motion is no longer detected.
Show Message: A Red M will show in live view to indicate that motion is being detected.
Send Email: Send an automated email when motion is detected. Your DVR must be hardwired to a router or
modem for this option to work. See page 21 for the steps to set up email alerts.
Full Screen: The channel detecting motion will go into full screen mode.
Record Channel (Analog Channels): Select the cameras that will record when motion is detected from one
camera. The DVR can be set to record on all channels, or select channels when motion is detected on one
channel.
Copy CH1 to All: Select to copy these settings to all channels.
Default: Restore the settings on this page back to default settings.
Save: Save the settings made on that page.
Cancel: Revert any changes, and exit the menu.