Specifications

MAINTENANCE
REMEW BRAKE SERVO FILTER
1.
2.
3.
4.
5.
6.
7.
Remove the nuts securing the master cylinder to
the servo.
Release the clip retaining the brake pipe to the
clutch pipe.
Separate the master cylinder from the servo.
Disconnect the vacuum hose from the servo.
Disconnect the Lucars from the stop lamp switch at
the rear of the pedal box.
Remove the blanking grommets from the pedal
box.
Remove the split pin from the clevis and withdraw
the clevis pin and washer.
8. Remove the four nuts securing the servo to the
pedal box and remove the servo.
ST1533M
i .-
'F"
9. Pull back the dust cover.
10. Release the end - cap.
11. Cut the filters to remove them from the shaft.
%L.
ST1485M
12.
13.
14.
Clean the filter seating and fit the new filters noting
6."-
'*
that they must be cut to fit over the shaft.
Fit the end - cap and dust cover and refit the servo
and master cylinder
to the vehicle reversing the
removal procedure. Use a new split
pin to secure
the clevis.
Test the brakes.
24