Specifications

10
RENEW FUEL FILTER ELEMENT - Diesel engines
Drain
off Water
FUEL SEDIMENTER
- Diesel engines (where fitted)
The sedimenter increases the working life of the fuel
filter by removing the larger droplets of water and
larger particles of foreign matter from the fuel.
Drain off water as follows:
1. Slacken off drain plug to allow water to run out.
2. When pure diesel fuel is emitted, tighten drain
Plug
-
MAINTENANCE
-
ST062
Renew filter
3. Support element holder.
4. Unscrew thc special bolt on top of the filter, the
element holder can now be removed.
5. Remove and discard the used element.
6. Wash the element holder in petrol or fuel oil.
7. If necessary renew both the large rubber washer
and the small rubber washer in the filter top, also
renew the large rubber washer in the element
holder.
8. Push the new elcment onto the filter top spigot
with the holes in the element
to the top.
9. Fit the element holder to the bottom of the
element, and secure with the special bolt.
10. Prime the system and check for fuel leaks.
14
Drain off Water
1. Slacken off drain plug to allow water to run out.
2. When pure diesel fuel is emitted, tighten drain
plug. Dismantle and clean as detailed below.
1
-/
ST 101 7M
Clean element
3. Disconnect fuel inlet pipe at sedimenter and raise
pipe above level of fuel tank to prevent draining
from tank. Support in this
positon.
4. Support sedimenter bowl and unscrew bolt on top
of unit and remove bowl.
5. Remove the sedimenter element.
6. Clean all parts in kerosene.
7. Fit new seals and reverse removal procedure.
8. Slacken off the drain plug, when pure diesel fuel
9. If necessary, prime the system.
runs out tighten plug.
Cu”
10. Start engine and chcck for leaks from sedimenter.
ST 1018M
w4