Specifications

/- 7 ->
?!! :?: 3
CLEAN ELECTRIC F’UEL PUMP FILTER - V8 and
later
2.25 Petrol engine vehicles
The pump is located mid - way along the right hand side
of the chassis.
1. Release the three bolts and remove the protective
cover
- except ‘90’ models.
1
ST 1014M
2. From beneath the vehicle disconnect the fuel inlet
pipe
from the pump and blank the end of the pipe
by suitable means to prevent fuel draining from the
tank.
3. Release the end cover from the bayonet fixing.
4. Withdraw the filter and clean by using a
compressed air
jet from the inside of the filter.
5. Remove the magnet (where fitted) from the end
cover and clean. Replace the magnet in the centre
of the end cover.
6. Reassemble the fuel pump and refit the fuel inlet
pipe.
7. Use a new gasket for the end cover if necessary.
8. Fit the protective cover.
r.
RENEW FUEL FILTER ELEMENT - Petrol engines
4
- cylinder and V8
The element provides a filter between the pump and
carburetter and
is located adjacent to fuel pump on the
right hand side of the chassis.
1. Release the three bolts and remove the protective
2. Unscrew the centre bolt.
3. Withdraw the filter bowl.
4. Remove the small sealing ring and remove the
element.
5. Withdraw the large sealing ring from the underside
of the filter body.
6. Discard the old element and replace with a new
unit.
7. Ensure that the centre and top sealing rings are in
good condition and replace as necessary.
8. Fit new element, small hole downwards.
9. Refit sealing rings (small and large).
cover. See ‘Clean electric fuel pump filter’.
10. Replace filter bowl and tighten
the centre bolt.
ST1075M kG2
‘\
12
13