Specifications

El MAINTENANCE
RENEW SWIVEL PIN HOUSING OIL
1. Drive the vehicle to level ground and place a
container under each swivel housing to catch the
used
oil.
2. Remove the drain plug and allow the oil to drain
completely and clean and refit the plugs.
3. Remove the oil filler - level plug and inject the
recommended make and grade
of oil until oil
begins to run from the level hole. Clean and fit the
level plugs and wipe away any surplus oil.
LUBRICATE PROPELLER SHAFTS
1. Clean all the grease nipples on the front and rear
propshaft universal joints, and sliding portion of
the rear shaft.
2. Charge a low pressure hand grease gun with grease
of a recommended make and grade and apply to
the grease nipples.
3. Remove the screwed plug from the front shaft and
fit
a suitable grease nipple.
4. Disconnect one end of the front propeller shaft and
compress the sliding portion whilst applying
grease. It is necessary to compress the shaft to
prevent
over filling with grease. It should be noted
that this sliding portion must only be lubricated at
40.000 km (24,000 mile) intervals.
5. Reconncct the propeller shaft, remove the grease
nipple and
fit the screwed plug.
TOP - UP MANUAL STEERING BOX
1. Remove the oil filler plug and observe the oil level
which should be
25 mm (1.0 in) below the top of
the filler hole.
2. If necessary top - up to the correct level with a
recommended oil. Clean and refit the plug and
wipe away any surplus oil.
ST
925M //
RENEW AIR CLEANER OIL - 2.25 litre engines
(early models)
1. Slacken wing nut and release the clamping strap
securing the complete air cleaner.
2. Disconnect the outlet elbow from the intake pipe
and remove the
clcaner from thc vehicle.
3. Remove the oil bowl from the bottom of the
cleaner by releasing the three securing clips.
4. Clean all dirty oil and sludge from the bowl and
refill with fresh engine
oil to the level indicated by
a ring formed in the pressing; the capacity is
approximately
0,85 litre (1.5 imperial pints).
5. Clean the spiral in the cleaner body by swilling the
complete body in paraffin and shake off the
ct
6. Remove and clean the air intake cap.
7. Clean the wire mesh filter.
8. Reassemble filter using a new scaling ring.
9. Refit the complete unit into the vehicle.
surplus. -d
6