Specifications

MAINTENANCE 110 I
DRAIN AND RENEW 230R AND 230T TRANSFER
GEARBOX
(4 - cylinder engine)
1. Drive the vehicle to level ground and place a
container under the gearbox to catch the old oil.
2. Remove the drain plug and allow the oil to drain.
Fit the plug using a new washer,
if necessary, and
tighten to the correct torque.
3. Remove the filler
- level plug and inject the
approximate quantity
of the recommended oil until
it begins to run from the plug hole. Fit the level
plug and tighten only
to the correct torque, do not
overtighten, wipe away
any surplus oil.
ST1070M
DRAIN AND RENEW LT95 MAIN GEARBOX (V8
engines)
1. Drive the vehicle to level ground and place a
container under the gearbox to catch the old oil.
2. Remove the drain plug, washer and filter from the
bottom of the gearbox casing and allow the
oil to
drain completely.
3. Wash the filter in petrol, allow to dry and fit to the
casing. Using a new washer, if necessary, fit the
plug and tighten to the correct torque.
4. Remove the oil filler - level plug from the side of the
gearbox and inject the approximate quantity
of the
correct oil until it begins to run from the filler
- level
hole. Clean and refit the plug using
a new washer
and tighten to the correct torque. Wipe away any
surplus oil.
DRAIN AND RENEW LT95 TRANSFER GEARBOX
OIL
1. Drive vehicle to level ground and place a container
beneath the gearbox to catch the old oil.
2. Remove the drain plug and allow time for the oil to
drain completely.
3. Clean and refit the drain plug using a new washer,
if necessary and tighten
to the correct torque.
4. Remove the oil filler - level plug and inject the
approximate quantity
of a recommended oil until it
begins to run from the hole. Clean and fit the plug
and tighten to the correct torque.
Do not
overtighten. Wipe away any surplus oil.
RENEW FRONT AND REAR AXLE OIL
1. Drive the vehicle to level ground and place a
container under the axle to be drained.
2. Using a spanner with a 13 mm (0.5 in) square drive
remove the drain plug and allow the oil to drain
completely. Clean and refit the drain plug.
3. Remove the oil filler - level plug and inject new oil
of a recommended make and grade until it begins
to run from the hole. Clean and fit the filler
- level
plug and wipe away any
surplus oil.
NOTE: Whilst the illustration shows a ‘90’ model
front differential, the procedure is the same for all
axles.
5