Specifications

1x1 MAINTENANCE
Renew oil filter - 2.25 petrol and diesel engine
RENEW MAIN AND TRANSFER GEARBOX OILS
DRAIN
AND REFILL LT77mm MAIN GEARBOX
4
- cylinder engines
@
8. Place oil tray under engine.
9. Unscrew filter retaining bolt.
10. Remove the container.
11. Remove the element.
12. Discard the used filter element and large rubber
washer.
13. Wash the container in kerosene.
14. Place the new filter element in the container and
reassemble the unit, using the new large rubber
washer supplied with the element.
15. Ensure that all the sealing washers are in position
and intact, and that the container is correctly
located in the adaptor.
16. Tighten the filter retaining bolt to the correct
torque.
Do not overtighten.
Sl
Refill sump with oil -all models
1. Drive the vehicle to level ground and place a
suitable container under the gearbox to catch the
old oil.
2. Remove the gearbox and extension case drain
plugs and allow the oil to drain completely. Wash
the extension case filter in kerosene and refit the
plugs using new washers, if necessary, and tighten
to the correct torque.
ST 919M U
3. Remove the oil filler - level plug and inject the
approximate quantity
of new oil of the correct
make and grade until
it begins to run out of the
filler
- level hole. Fit the plug and tighten to the
coirect torque. Since the plug has a tapered thread
it must not be overtightened. Wipe away any
surplus oil.
17. Check that the drain plug is tight.
18. Clean the outside of the oil filler cap, remove it
from the rocker cover and clean the inside.
19. Pour in the correct quantity of new oil
of the
correct grade from a sealed container to the high
mark
on the dipstick and firmly replace the filler
cap.
20.
Run the engine and check for leaks from the filter.
Stop the engine, allow the oil
to run back into the
sump for a few minutes, then check the
oil level
again and top
up if necessary.
4