Specifications

GENERAL SPECIFICATION DATA 1041
,,:?.% Valve springs
.... 7 Type Duplex interference coil
..............................................................
Inner:
Length, free
................................................ 42,67 mm (1.680 in)
Length, free
................................................. 46,28 mm (1.822 in)
Length, under
8,0 kg (17.7 Ib) load ....................
37,13 mm (1.462 in)
Outer:
Length, under 21
kg (46 Ib) load ........................
40,30 mm (1.587 in)
Lubrication
System ...........................................................
System pressure, engine warm at 2000 rpm .............
Type ...........................................................
Radial clearance of gears .................................
Oil pump:
Drive
..........................................................
End-float of both gears.. .....................................
Backlash of gears ...........................................
-.
...
Oil pressure relief valve
Relief valve spring:
Type
..............................................................
Full length ....................................................
Compressed length at 2,58 kg (5.7 lb) load ...........
Wet sump, pressure fed
2,45 - 4,50 kgf cm2 (35 - 65 Ibf in2)
Double gear, 10 teeth, sintered iron gears
Splined shaft from camshaft skew gear
0,026
- 0,135 mm (0.0009 - 0.0045 in)
0,025
- 0,075 mm (0.0008 - 0.0025 in)
0,l - 0,2 mm (0.0034 - 0.0067 in)
Non-adjustable
67,82 mm (2.670 in)
61,23 mm (2.450 in)
2.25 LITRE DIESEL ENGINE
ENGINE
Type .................................................................
Capacity ............................................................
Valve operation. ..................................................
Bore .................................................................
Stroke ...............................................................
Compression ratio.. ..............................................
Maximum power .................................................
Maximum torque .................................................
4 cylinder
90,47 mm (3.562 in)
88,9 mm (3.500 in)
2286
cm3 (139 in3)
Overhead by push-rod
23:l
44Kw (59 bhp) at 4000 rpm
136 Nm (100 Ibf ft) at 1800 rpm
Crankshaft
Main bearing journal diameter.. ........................... 63,487 - 63,500 mm (2.4995 - 2.500 in)
63,246
- 63,2333 mm (2.490 - 2.4895 in) ............... Use 0.010 in U/S bearings
Crankpin journal diameter
.................................. 58,725 - 58,744 mm (2.312 - 2.31275 in)
58,48985
- 58,4708 mm (2.30275 - 2.30200 in). ....... Use 0.010 in U/S bearings
Taken
on thrust washers at centre main bearing
0,05 - 0,15 mm (0.002 - 0.006 in)
Regrind dimensions:
Regrind dimensions:
Crankshaft end thrust
........................................
Crankshaft end-float ..........................................
Main bearings
Number and type ..............................................
5 halved shells
0,020
- 0,063 mm (0.0008 - 0.0025 in)
Material
.........................................................
Diametrical clearance ........................................
Steel shell, copper-lead lined, tin plated
7