Instruction manual
DFDVR2 18
4-3-1: RECORD SETUP
This screen allows you to adjust quality settings for each camera independently.
1. CHANNEL - Select the camera channel you want to congure.
2. RESOLUTION - Set recording resolution.
704×240 (NTSC) / 720×288(PAL)
352×240 (NTSC) / 360×288(PAL)
3. QUALITY - This sets up the recording picture quality. The quality levels are: Low / Mid
/ High / Super / Hyper. To send more images and longer recording times faster over the
network, set the Quality to “Low” or “Mid”, Frame Rate to a lower number, and
Recording Resolution to 352×240(360×288).
4. FRAME RATE - Sets the recording speed when an alarm is triggered.
NTSC - 1~30 FPS
PAL - 1~25 FPS
4-3-2: SCHEDULE SETUP
This screen is used to program a weekly recording schedule. This schedule will
be in effect every week until you make changes. Each camera must be scheduled
independently.
1. CHANNEL - Allows you to select the camera channel you would like to schedule.
2. TYPE - Allows you to select a recording mode. The recording modes are as below:
C: Set as continuous record.
M: Sets as motion record, this triggers recording when there is motion detected
A: Set as Alarm record. When there is an alarm triggered.
M&A: Set as Motion+ Alarm record.
3. ALL - By clicking on the times at the top, all blocks for the time can be activated or
deactivated for the whole week.
4. 0~24 Hour - To activate or cancel the hours in a week which are scheduled.
5. SUN~SAT - To activate or cancel the hours scheduled in a day.