User manual

Active Video Transmitter
The NVT model NV-653T video transmitter is an active (amplified)
device that allows the transmission of real-time monochrome or color video
up to 1.5 miles using Cat 5 unshielded twisted pair when used with an NV-652R. The
unparalleled interference rejection ability of the Model NV-622R allows long run video
signals to co-exist in the same wire bundle as telephone, datacom, or low-voltage power
circuits. This allows you to use the shared or existing cable plant. Built-in ground-lifting
ensures no annoying “hum-bars” when ground potential
differences exist. With built-in transient suppression,
damaging voltage spikes are eliminated. Mfr. #NV653T.
15
321
Order Toll Free
1-800-543-4330
Fax
1-800-765-6960
NET 30
Terms
Security
section
15
Installation Accessories
Video Baluns
Video Ground
Loop Isolator
Ground loops
in CCTV
composite video
systems can cause video distortions
such as herringbone and AC beat. Uniquely
designed to eliminate ground loop related distortions,
this transformer features BNC female-to-female
connectors with a separate 9' BNC male-to-male
pigtail that facilitates multiple installation
configurations and helps reduce cable and connector
strain. Specifications: •Insertion loss: <0.5db
•Frequency response: 0~3db @ 10MHz •Input/output
resistance: 75ohm •Built-in 600VDC transient
voltage surge suppression (12V RMS) •No power
required (passive).
Order # (1-3)
82-6131 $29.95
TM
Mini-Coax CCTV Video/Power Cables
Easily extend your video and power connections
up 150' with flexible, light-weight, pre-terminated
mini-coax patch cables. Specifications: 75ohm,
EMI-RFI shielded, low-loss mini-coax (OD is 0.167"
nominal) video cable bonded with power cable
(5.5mm x 2.0mm male/female DC barrel connectors).
Includes two BNC to RCA adaptors to accommodate
common camera video connections.
Order # Length (1-4) (5-up)
24-9675 25' $12.99 $10.39
24-9676 50' 24.99 19.99
24-9677 75' 29.95 23.39
24-9678 100' 39.99 31.99
24-9679 150' 59.99 47.99
CCTV Installation Cables
Make your CCTV installations quick and
easy with pre–made CCTV cables. Combination
video/audio/power or video/power with BNC or
RCA type connectors for video, RCA type connectors
for audio and 5.5 x 2.0 DC barrel connector for
power (male/female).
Order # Video Cable Length (1-9) (10-up)
Video/Power
24-5280 BNC 25' $11.39 $9.56
24-5285 BNC 50' 26.95 21.71
24-5290 BNC 75' 30.95 24.92
24-5295 BNC 100' 13.99 -
24-5300 RCA 25' 11.39 9.56
24-5305 RCA 50' 26.95 21.71
24-5310 RCA 75' 30.95 24.75
24-5315 RCA 100' 9.99 -
Video Motion
Detector
Motion detection
by digital signal
processing allows
this unit to be placed
at the monitor end
of the system out of
sight. Compatible
with color or black
and white cameras.
Four sensitivity levels. Easy to connect in-line with
the camera’s video cable. Adjustable detection time,
0.6 second or 3 seconds selectable to trigger alarm.
Alarm output: Buzzer, 9VDC, N.O. contact. N.C.
contact. Power: 9VDC, 300mA via supplied adaptor.
Note: The Video Motion Detector is designed to be
installed after the camera and before switchers,
etc. Improper installation will result in
continuous alarm.
Order # (ea.)
82-9270 $81.55
Front
Back
Distribution Amp
Video distribution
amp operates with
both color and black
and white systems.
This unit distributes
a single composite
video signal to up to
four monitors. Video input/output via
BNC type connector. Mfr. #VID-D.
Order # (ea.)
82-10675 $69.95
Video Amplifier
Compensate for
signal loss due to
long cable runs.
Placement is at the
system (monitor)
end of the cable. Maximum cable length is: RG-59U =
3000', RG-6U = 4500' and RG-11U = 6000'. Separate
low frequency and high frequency gain control.
Order # (ea.)
82-8870 $71.35
Video Distribution
Amplifier
Split a single video
signal for use or
view on four devices (monitors, switchers, VCRs,
etc.). All outputs and inputs are BNC. Gain is 0dB.
Order # (ea.)
82-8875 $71.35
1 x 2 Distribution Amplifier
Provides two video outputs
from one input to split video
sources. Dual power operates
on 12VDC or 24VAC. Includes
12VDC power supply.
Order # (ea.)
82-9355 $26.95
Active Video
Transceivers
Active video
transceivers allow
transmission of real-time
color or black and white video plus 12VDC power
up to 7500' over Cat 5e UTP cable. Perfect for aerial
runs between buildings, or in your existing premise
network cable structure. Optional 2U rack panel holds
up to nine transceiver units. 12VDC regulated, 300mA
power adaptor included.
Order # Description (ea.)
82-11265 Transmitter $34.95
82-11170 Receiver 39.95
82-9315 Rack panel 59.95
#82-11265
#82-11170
Active Video Receiver
The NVT
model NV-652R is an
active device that allows the
transmission of real-time
monochrome or color
video up to 1.5 miles
using Cat 5 unshielded twisted pair
when used with an NV-653T or up to 3,000'
when used with an NV-213A, NV-213A-M, NV-813A
or NV-1613A. The unparalleled interference rejection
ability of the Model NV-622R allows long run
video signals to co-exist in the same wire bundle as
telephone, data comm, or low-voltage power circuits.
This allows you to use the shared or existing cable
plant. Built-in ground-lifting ensures no annoying
“hum-bars” when ground potential differences exist.
With built-in transient suppression, damaging
voltage spikes are eliminated. Mfr. #NV-652R.
Order # (ea.) (2-up)
82-6590 $277.79 $259.03
Order # (ea.) (2-up)
82-6595 $277.79 $259.03
Video Transceivers
The transceiver is a passive device that
allows for transmission of full motion
video over ordinary telephone wire for distances to
1000'. Transmits color or black and white with no
external power required. Patented crosstalk immunity
allows you to send video signals in the same wire
bundles as telephone, data comm and low voltage
power without a hint of interference. The NV-213A
offers built in surge suppression.
Can be rack mounted.
Order # Mfr. # Distance (ea.) (2-up)
82-2950 NV-212A 500' $99.95 $92.65
82-2955 NV-213A 1000' 149.00 143.17
#82-2955
#82-2950
C52_pg_321 8/13/07 3:01 PM Page 321