8.0” Rack-mountable TFT LCD MONITOR User Manual Part Number 82-12455 Version: V0.
Notice: Federal Communications Commission (FCC) This equipment has been tested and found to comply with the limitations for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
hazard if the cover is removed. Unplug the power cord in case of the following situations: The power cord is damaged. Liquids are splashed on the system. The system is dropped onto the ground or the chassis is damaged. If the system is damaged, please package it carefully for repair. Always use the polarized, grounding-type plug supplied with the unit. Using a non-grounded plug can cause damage to the unit, especially in lightening storms.
Part 1 Introduction........................................................ 5 Check the Contents of the Package.......................................... 5 Understand Each Part ................................................................ 5 Description of the Function Buttons ........................................ 7 Control Operation................................................................................... 7 OSD Menu .............................................................................
Part 1 Introduction This section describes the preparation before start up and the operation of the function buttons. • “Understand the contents of the package.” • “Understand each part.” • “Understand the operation of the functions.” Package Contents □ 8.0” TFT LCD Monitor x1 □ Power cord x1 □ User’s manual x1 Understand Each Part This section describes each part of the monitor.
Overview of the Rear Side of the Monitor 8 1 9 2 3 10 4 5 6 11 12 13 7 Description 1 Audio 1, input terminal for the right channel (AUDIO 1 R IN) 2 Audio 1, input terminal for the left channel (AUDIO 1 L IN) 3 Audio 2, input terminal for the right channel (AUDIO 2 R IN) 4 Audio 2, input terminal for the left channel (AUDIO 2 L IN) 5 Audio output terminal for the right channel (AUDIO R OUT) 6 Audio output terminal for the left channel (AUDIO L OUT) 7 Support stand 8 Video 1 input term
Description of the Function Buttons Control Operation POWER ─ Power on/off switch SOURCE ─ Signal source switch MENU ─ On-screen display of menu/confirm operation UP ─ Move up/Increase (Turn the volume up ) DOWN ─ Move down/decrease(Turn the volume down) OSD Menu 1. LANGUAGE ─Language 2. CONTRAST ─Contrast 3. BRIGHTNESS ─Brightness 4. COLOR ─Color 5. TINT ─Tint 6. SHARPNESS ─Sharpness 7. RESET ─Reset 1. When the MENU button is pressed, the monitor will show the main menu. 2.
Part 2 Assembly of Accessories This section describes how to assemble two monitors together. Assembly Description Connecting the Monitors Rack mount bracket Screws for the rack mount bracket Rack mount bracket Rack mount bracket 1 Place the saw-shaped side of the rack mount bracket towards the BNC side for the monitor connection and then fasten the six screws for the rack mount brackets.
Disassembly of the Support Stand 1 After removing the screws from the support stand, the support stand can be removed.
Specifications Item Specification LCD Monitor 8” TFT LCD Monitor Resolution 800mm(H) x 600mm(V) Contrast 500 Brightness 300cd/m2(MIN.) Response Time (Tr / Tf) 10 / 15ms(TYP.) Viewing Angle Left/Right 70o/70o(MIN.) Viewing Angle Up/Down 70o/70o(MIN.) 2 x BNC Inputs (1.0Vp-p 75Ω) Input 1 x S-Video Inputs 1 x Audio Input (RCA Jack R,L) 2 x BNC Outputs (2.
