Owner`s manual

4 System Setup
SuperDVR & TD Series Cards
User Manual
36
1. Video Loss
Users can select alarm output for this option. For example, users select
alarm_out1 and alarm_out3 for video loss. Then video loss of any channel will
trigger alarm_out1, alarm_out3 to show red light in the Alarm output status
panel (refer to Figure3-6 for reference).
2. Disk Alarm
When HDD available space is less than the set value (see Figure4-9), it will
trigger alarm.
3. Sensor
Sensor 1: If users have mounted sensors, when the sensors have been
activated, then it will trigger the selected output alarms.
Sensor 2 - Sensor 16: TwoTD4116 cards have maximum 16 sensors.
4. Motion
Motion 1: Users can set the output of motion detection alarm by different
alarms and remote alarm.
Motion 2 - Motion 16: 32CH card has maximum 16 motion alarms.
NOTICE
You should choose our additional alarm device board while using twoTD4116 cards for
alarm I/O.
4.5.4 Auto Mail Function
Now users can select the above-mentioned alarms to be output by Auto Mail.
Click ‘Auto Mail’ icon on the left top side of alarm configuration page and
enter the following area to make Auto Mail setup, referred Figure4-12.
Figure4-12 Auto Mail Setup Interface
In this area, users can set receiver and sender’s E-mail SMTP server and
address. Note: the address of receiver and sender can be the same.