Owner's manual

18
• another reading is taken, in which case
the sequence starts over.
• the 88 button is pressed, in which case
the last reading is displayed.
HILO Mode must be off to activate
STATISTICS Mode. Adjustments cannot be
made to readings while in STATISTICS
Mode. To turn STATISTICS Mode off,
select STATOFF?STATOFF?
HiLo Mode
(Main Menu)
Standard (2) and Memory (3) models only
When HiLo ON?HiLo ON? is selected, the
current LoLo setting is displayed. Adjust
down 88 or up 99. Alternatively, measure a
coating with a thickness close to the
required value and make final
adjustments with the 88 99 buttons. Press 88
99 simultaneously to accept this value.
The last HiHi setting is now displayed.
Follow the same procedure to adjust the
HiHi setting. The symbol will indicate
HiLoHiLo Mode is now ON.
Measurements will now be compared to
your defined limits. The Gage BEEPS
TWICE (normal) if results are within those
limits and ONCE if outside. The single
BEEP is a LOW tone with a æ if it is
below the Lo limit, and a HIGH tone with
a ä if it is above the Hi Hi limit.
NOTE: The LED will only BLINK if
readings are within limits.
STATISTICS Mode must be off. Calibration
adjustments cannot be made while in
HHIILLOO MODE. To turn HHIILLOO MODE off
select "HiLoOFF?HiLoOFF?".