Installation manual

Press button B to indicate the current setting.

1 flash = Function is not selected

2 flashes = Panic function is active when buttons A and B are held simultaneously (standard)

3 flashes = Panic function is activated for 30 seconds after buttons A and B were

held simultaneously. The buttons can be released in the meantime.

Press button B again to select the next function. The number of confirmation signals indicates the

current status.

Function 12: Factory settings

The following settings are provided ex works:

Function 3: Alarm sound no. 1

Function 4: Active arming

Function 6: Programming of all functions (setting 3)

Function 7: Activation time of Central Locking; 0.5 seconds

Function 8: Security function not selected

Function 9: Start lock selected (821). Immobilizer selected (823)

Function 10: Convenience closing; OFF

Function 11: Panic function, active for as long as A and B buttons are held

If the actual settings differ from the factory settings, they can be reset to the above settings by pressing

button B.

Function 13: Entry of PIN code in Immobilizer Unit

If an Immobilizer module is retrofitted or replaced, the PIN code must be entered into the alarm to

allow the vehicle to be started.

1. Press button B

2. Switch ignition OFF

3. Switch ignition ON, allow LED to flash the same number of time as the first digit of the Immobilizer

PIN code

4. Switch ignition OFF

5. Repeat points 3 and 4 until you have entered all of the digits of your PIN code. When the ignition is

switched off for the last time, the LED will flash rapidly. This means that you have completed the

coding.

6. If you make a mistake, you will have to restart the procedure from the beginning.