Installation manual

17
Function 6: Setting of Remote Control with Slider Switch
The Remote Control with Slider Switch can be programmed for 3 different modes:
Programming Press A Hold A Press B Hold B Position of
Slider Switch
1 flash Alarm
ON
Close
windows
Alarm
OFF
Windows open
2 flashes Alarm
ON
Close sliding
roof
or
Channel 2
Alarm
OFF
Open sliding
roof
or
Channel 1.
(Open luggage
compartment)
3 flashes
(Standard)
Alarm
ON
Close tilted
sliding roof
or
Channel 3.
(Car heating
ON)
Alarm
OFF
Tilt sliding roof
or
Channel 3.
(Car heating
OFF)
Programming 1 provides the functions in line 1 of the table
Programming 2 provides the functions in lines 1 and 2 of the table
Programming 3 provides the functions in lines 1, 2 and 3 of the table
If programming 1 is selected, the middle and top Slider Switch positions can be used to operate the
alarms in 2 other cars.
If programming 2 is selected, the top Slider Switch position can be used to operate the alarm in one
other cars.
If only the electric window winders are to be operated, the original Remote Control can be used (1:1).
A Remote Control with Slider Switch is not required.
A precondition for programming is that the Remote Control has been coded with the Slider Switch in
the bottom position.
Press button B to indicate the programming of the Slider Switch: 1 signal corresponds to point 1, 2
signals to point 2 and 3 signals to point 3. Press button B again to select the next programming
procedure or hold button B to select the preceding programming procedure. The number of
confirmation signals indicates the selected programming procedure.