Installation manual

Programming the alarm Further information, see technical manual.

The alarm contains a register that allows various functions to be programmed or altered using the

Remote Control and the ignition key. Please read the detailed function description on the following

pages.

Function Description

1 Cause of Alarm trigger

2 Number of Remote Controls

3 Alarm sounds

4 Passive arming

5 The sensitivity of the Microwave Sensor

6 Remote Control with Slider Switch

7 Central locking - time

8 Central locking - security function

9 Starter kill/Immobilizer

10 Convenience locking

11 Panic function (Remote triggering of alarm)

12 Production settings

13 Entry of PIN code for Immobilizer

Definition of pressing and holding programming buttons on Remote Control :

Press means: press for a maximum of 1 second.

Hold means: press for at least 2 seconds.

Procedure for programming:

A) Switch the ignition ON and OFF five times. The LED flashes rapidly.

B) Switch the ignition ON again, allow the LED to flash twice and switch the

ignition OFF again. Repeat 5 times. After the fifth time, the LED will flash

rapidly when the ignition is switched OFF again.

C) Switch the ignition ON. Press button A to activate function 1. The function that

is active is indicated by the number of sound signals.

D) Pressing button A again activates the next function. Hold button A to return to

the previous function.

E) Once you have reached the desired function, you can program or alter the

function as described on pages 16, 17, 18 and 19.

F) If you want to program some more functions, press button A. You can then

select the function by either pressing or holding button A.

G) Once you have completed programming, switch the ignition OFF.