Installation manual

13
Coding of new Remote Control Units Further information, see technical manual.
A Press button B to switch the alarm and the Immobilizer (if present) OFF. The
emergency deactivation can also be used.
B Switch the ignition ON and OFF 5 times. The LED flashes rapidly.
C When you switch the ignition ON again, the LED should flash. Allow the LED
to flash as many times as the first number of your PIN code and then switch
the ignition OFF again (the LED stops flashing).
D Switch the ignition ON again and repeat the procedure until all digits of the
PIN code have been entered.
E The LED flashes rapidly. If you make a mistake, start again at «C» with the
first digit of the PIN code.
F Switch the ignition ON again and press buttons A and B of the Remote Control
Unit being programmed simultaneously (one Remote Control Unit at a time).
Press both buttons until you receive the sound and light confirmation.
G Switch the ignition OFF once all Remote Control Units have been coded.
Important: Coding the keys deletes the old codes, A maximum of 4 Remote Control Units can be
coded.
Connection of Central Locking Further information, see technical manual.
P-1 Multiplug, Central Locking
Plug for connection of the Central Locking, cf. diagram, page 14
The plug for the Central Locking P-1 must be configured (assigned) for the relevant car. If the function
of the Central Locking is unclear, the original circuit diagrams for the car must be consulted. Always
check with a voltmeter/multimeter before making any connections. The leads in the P-1 plug which are
not used must be disconnected or insulated.
Important: Each relay in the Central Unit can be loaded with a maximum of 15 amps. The
Central Unit can become damaged if correctly wired or overloaded. Output P-1.1 is fused by an
automatic circuit breaker.
P-1
Plug Function Colour
P1.1
Battery + Red/white
P1.2
Lock NC White/orange
P1.3
Ground Black/white
P1.4
Unlock COM Yellow
P1.5
Lock COM White/blue
P1.6
Lock NO White/brown
P1.7
Unlock NO Green
P1.8
Unlock NC Lilac