Installation manual

11
User Instructions Further information, see technical manual.
Your DEFA Auto Security Alarm is activated using the two buttons (A and B) on the Remote Control.
The two buttons are easy to tell apart, as button A is noticeably higher.
«Press» means that you press the button for a maximum of 1 second. «Hold» means that you press the
button for at least 2 seconds
Alarm ON (arm)
Press button A.
The turn signal lamps flash once and the alarm siren emits a «click» to confirm that the alarm is ON.
The LED illuminates for 20 seconds and then starts to flash, to confirm that the alarm and the
Glassbreake/Microwave Sensor are switched ON.
Temporary deactivation of Sensors
You can also set the alarm to ON without activating the sensors for motion in the interior or impact
against the screen. This can be necessary if, for example, a pet is left in the vehicle. Quickly switch the
ignition ON and OFF again. Exit the vehicle and, within 30 seconds, press button A twice briefly
(maximum 3 seconds between pressing). The LED starts flashing immediately. The turn signal lamps
illuminate for approx. 1 second.
The sensors are reactivated when you switch ON the alarm the next time.
Button B
Button A
Press button A