Instructions / Assembly

TWO-PIECE TOILET
INSTALLATION INSTRUCTIONS
-3-
NOTE: Drawings may not exactly define contour of the product.
([phone]
www.deervalleybath.com
([phone]
www.deervalleybath.com
1. Remove Old Toilet
Turn off the water supply.
Flush the toilet to empty the tank. Remove any water left in the tank or bowl.
Disconnect the supply line from the tank.
Remove decorative caps. Unscrew nuts that attach the toilet to the floor.
Remove toilet.
Make sure the water supply valve is shut off before installation.
Remove old closet bolts from closet flange. Clean any old wax, putty, etc. from base area.
NOTE
: This is a true 12" rough-in toilet from finished wall to center of the drain
(no less than 12" ). Baseboard thickness may reduce rough-in dimension.
IMPORTANT NOTE REGARDING WATER SUPPLY
:
Before installation ensure that the shut-off valve is greater than 7 1/2" from the center of the
drain to the center of the shut-off valve on either side.
NOTE: Drawings may not exactly define contour of the product.
7 1/2”
Shut-Off Valve
Finished Floor