Installation Guide

2. Install the Floor Bolts and L-bar 3. Install Wax Ring
Install the floor screws to the toilet flange to
adjust to the proper position. Please note that
the two screws and the center of the flange
must be in a straight line.
4. Position Toilet on Flange
Place the toilet on the flange then rock to
press the bowl completely tight on the wax
ring and flange.
5. Install Toilet
Connect the flexible water supply line
(not included) to the shut-off valve and
perform a flush test to check for leaks.
Attach the screws to the plastic sleeve and
install in the two small holes on the side of the
toilet, fasten with a cross screwdriver and then
install the cap.
Place the L-Bar, washer and nut in sequence
and tighten the nut after pulling the L-Bar to
its maximum distance.
Install the wax ring and adjust the L-bar and
fasten it. Please make sure the L-bar in a
straight line.
([phone]
www.deervalleybath.com
-4-
NOTE: Drawings may not exactly define contour of the product.
L-Bar
Nut
Washer
Wax Ring
Cover Cap
Screw
Plastic Sleeve