Installation Guide

-3-
NOTE: Drawings may not exactly define contour of the product.
([phone]
www.deervalleybath.com
([phone]
www.deervalleybath.com
NOTE: Drawings may not exactly define contour of the product.
1. Remove Old Toilet
Turn off the water supply.
Flush the toilet to empty the tank. Remove any water left in the tank or bowl.
Disconnect the supply line from the tank.
Remove decorative caps. Unscrew nuts that attach the toilet to the floor.
Remove toilet.
Make sure the water supply valve is shut off before installation.
Remove old closet bolts from closet flange. Clean any old wax, putty, etc. from base area.
(1) Shut-Off Valve Distance
Before installation ensure that the shut-off
valve is greater than 7 1/2" from the center
of the drain to the center of the shut-off valve
on either side.
NOTE
: This is a true 12" rough-in toilet from
finished wall to center of the drain
(no less than 12" ). Baseboard thickness may
reduce rough-in dimension.
(2) Inlet Valve Adapter Included
The toilet inlet valve connection comes with an
adapter so that the size of the water supply line
that can be connected is 1/2" and 7/8", please
tighten or unscrew the adapter according to
your supply line size to connect.
7/8”
7 1/2”
Shut-Off Valve
Finished Floor
1/2”
IMPORTANT NOTE REGARDING WATER SUPPLY: