Instructions / Assembly

([phone]
www.deervalleybath.com
-4-
NOTE: Drawings may not exactly define contour of the product.
Installation and
Owner’s Manual
WARNING
When using in shower room, please install air exchange equipment to ensure the air in
the shower room not too moist. This product is electric products, it is not allowed to
install it in the place that is easy high wet, easy split by water, otherwise it might trigger
electric shock or fire.
Please ensure to cut off the electric power before washing this product, do not use
water to directly wash this product, otherwise it might trigger the electric shock or fire.
Please put and use this product in the shadow, must not put directly beneath the sun,
otherwise it might cause the color-fading, or burn the surface of product due to the
instability of temperature.
Do not use industrial water, wastewater, seawater, reclaimed water and other sewage,
otherwise it may cause skin inflammation and other problems.
Persons (including children) with physical, perceptual, intellectual disabilities or lack of
experience and common sense need to use the product under the guidance or
supervision of someone else, or they may cause electric shock, injury or fire.
Please notice the assembly location of electric wiring plug, electric plug should be the
water-proof plug. Assembly location of electric plug must be over 0.5m (19.7in) above
the floor, and far away from shower, bathtub, otherwise it might cause electricity
leakage.
When installing this product, please remove the old hose assemblies owned by users
and install them with new hose assemblies. Do not reuse the old hose assemblies to
avoid related safety problems.
The grounding wire of this product must conform to the stipulated construction mode,
and the three-level grounding structure must be grounded, otherwise the use of this
product is prohibited.
In the same room where this product is installed, a switch of water inlet angle valve
needs to be installed at a location within reach. It is used in emergency situations to cut
off the waterway of this product without the aid of tools; otherwise, unexpected failures
of this product may occur and it will cause user loss.
If you have not used this product for a long time, please close the angle valve, press
the water release button to drain the water of ceramic itself and cut off the power; When
using the product again,please wash first to prevent water quality problems and skin
diseases.
When the outside air temperature is lower than 0°C, in order to prevent water leakage
caused by external filter and other accessories likely freezing, please be sure to close
the water inlet valve and drain the left water; If pipe has been frozen, please raise the
room temperature and wait for pipe normal then use the toilet, otherwise the product
may not be used normally.
Electric plug need to plug in the electric with air switch.
Caution