Installation Guide

4. INSTALLATION STEPS
([phone]
www.deervalleybath.com
Step 1: Verify Sink Location
Consider your bathroom layout and choose either the floor
drain or wall plumbing for the waste connection. Select the
appropriate connector or fitting for the chosen connection.
Confirm the requirements of the selected system before
installation. The illustrations are for wall plumbing
installations only.
Use a pencil to mark the desired sink location on the floor.
Step 2: Connect Pipes
Install waste and overflow into sink basin.
Screw plumbing pipes into the basin.
(Plumbing not included)
Note: The location of the 1 ¹⁄
2”discharge pipe may vary
between models and may need adjustment before
installation.
x”
Discharge Pipe
Step 3: Connecting Plumbing
It's recommended to install the faucet (not included)
while the back of the sink is accessible.
Align pipes in the basin with the chosen plumbing
connection.
Tighten into place with a clockwise motion.
Ensure the water shutoff valve is slightly above the 1 ¹⁄
2 ”
drain line coming out of the wall.
Step 4: Seal Sink (2 People Required)
Dry fit the pedestal sink before final installation.
Person 1: Slightly tilt the sink back so the basin barely
lifts off the ground.
Person 2: Apply construction adhesive underneath the
sink. Then, both gently lower the basin back to a standing
position.
Caulk the sink to the floor using silicone or sealant. Do not
use the sink until 24 hours after sealing.