Installation Guide

-3-
([phone]
www.deervalleybath.com
1. TOILET TANK CARRIER SYSTEM INSTALLATION
2. TOILET INSTALLATION
(1) Dry Fit Outlet Pipe and Inlet Pipe
Firmly insert the straight pipe into the cistern flushing outlet and then insert the connecting
pipe into the discharge outlet on the wall. Draw lines to mark as the following picture shows.
Apply lubricant on the straight pipe and the connecting pipe and then fully insert these two
pipes into the toilet bowl. Draw lines to mark as the following picture shows.
(2) Cut the Extra Length of the Pipe
Measure the distance between the two marks on the straight pipe and the connecting pipe.
Take measured distance, and deduct from the bald end of the pipe and cut pipes as the
following picture shows.
After cutting, take a file and remove all burrs.
L1: The distance from the two marks on the straight pipe.
L2: The distance from the two marks on the connecting pipe.
The in-wall tank carrier system (SOLD SEPARATELY) is required to be installed before the
toilet bowl installation.
The straight pipe and the connecting pipe are included with tank carrier system
(SOLD SEPARATELY).
NOTE: Drawings may not exactly define contour of the product.
WALL HUNG TOILET
INSTALLATION INSTRUCTIONS