Installation Guide

STEP 1：

Drill two holes in the requied position on the wall using a

14mm masonry drill bit ,to depth of 75mm.

STEP 2：

Push a wall plug into each hole.

STEP 3：

Screw a fixing bolt into each fixing plug using an 8mm

spanner until the spanner contacts the wall.

STEP 4：

Place the basin in position against the wall.Locating the

fixing bolts through the holes in the rear of the basin.

Push a plastic washer followed by a metal washer, onto

each fixing bolt.

STEP 5：

Screw a metal nut onto each fixing bolt to secure the

basin.

Caution: Do not over-tighten,as this may damage the

ceramic.

(+1) 312-626-9466