Installation Guide

NOTE: These fixings are suitable for solid walls only. Plasterboard or stud walls may require specialist
fixings (not supplied).
CAUTION: Take care when drilling walls and floors to avoid any concealed wires or pipes.
Before Installation :
1. Prior the installation, unpack your product and inspectit keep the product in its original package
until you are ready to install it;
2.Shut the water supply off when replacing an existing fixture. Preparation of the floors and walls,
including all additional wall supports, may be required;
3.Observe all local plumbing and building codes;
4.Do not install this fixture alone.
(4) INSTALLATION STEPS
([phone]
www.deervalleybath.com
(1) Assemble Console
Using the provided hardware assemble the console as illustrated.
NOTE: Height of console is NOT adjustable.
4
x2
(2) Install Sink
Use your assembled console to mark on the wall where the bottom of the sink should rest.
Following the steps illustrated below, install your sink.
NOTE: Make sure your sink is LEVEL before marking and securing into place.