Contents 1.0 Disclaimer&Warning 2.0 Safety Guidelines . 3.0 Maintenance .. 4.0 Package Contents 5.0 Drone’s Details 6.0 Transmitter Details 7.0 Jay stick Mode . 8.0 Charging 9.0 Installation 9.1 Propellers 9.4 Transmitter Battery. 9.5 Phone Holder 10.0 Operation Guide 10.1 Download APP 10.2 Connect to WiFi 10.3 Paring 10.4 Calibrating the Gyroscope 10.5 One Key Takeoff/ Landing 11.0 Functions Details 11.1 Emergency Stop .. 11.2 Speed Switch 11.3 Trimmer Function 11.4 Take Photo/ Video 18 11.
1.0 DISCLAIMER & WARNING 1. Please read this Disclaimer & Warming and Safety Guidelines carefully before using our product. This product is not recommended for people under the age of 14. By using this product, you hereby agree to this disclaimer and signify that you have read it fully. You agree that you are responsible for your own conduct and any damaged caused while using this product, and ts consequences .
@ Please do a thorough check of the product before sate use. Inspect the integrity of the parts, any signs of cracks and wear of the propeller, battery power and effectiveness of the indicator, etc. If after doing a complete check any Issues are found, please refrain from using the product undo the issue has been resolved. 2.
2.3 Operation Requirements: @ Please don't use this product to follow any moving vehicles . @ During the flight. only tum off the motor in case of an emergency. @ As battery becomes low return the drone back to your starting point. @ This product should not be used while drinking alcohol, if you are feeling fatigued. aching medicine, or feeling any physical discomfort. ® Beware of the noise volume the drone produces. Keep your distance to avoid ear damage.
@ tis recommended to only use the USB charging cable that comes with the drone to charge the battery. ® Don't connect the battery directly to wall outsets or car cigarette Righter sockets. ® Don't attempt to disassemble or modify the battery in any way. ® Don't use the battery if it gives off an odor, generates heat. becomes discolored or deformed.or appears abnormal in any way. If the battery is in use or being charged, remove it from the device o charger immediately and discontinue use.
3.0 MAINTENANCE @ Clean the product after each use with a clean, soft cloth. @ Avoid prolonged exposure to direct sunlight and avoid buildup of heat on the drone. @ This device is not waterproof and must not be submerged in water under any circumstance. Allure to maintain the device completely dry will resulting the failure of the unit. @ Check the charging plug and other accessories for signs of damage frequently.
5.0 DRONE'S DETAILS W Propeller B Propeller B Power Switch & Propeller A HD Camera & 6.
7.0 JOYSTICK MODE 7.1 MODE 2 ;. hand throttle MODE 2 will be default sting) Left Joystick , Right 7.2 MODE 1 To enter MODE 1, turn on the transmitter while holding the “Speed Switch” mutton. {Possess o not release the “Speed Switch” button until B1e transit.
8.0 CHARGING > Power Bk Comp inter Usa Port 1) When the drone battery runs low, the indicator lights on the drone wil flash continuously. 2) Remove the battery and connect the USB charging cable to the battery. 3) Plug the USB charging cable into a USB charging port on the computer, power bank or USB adapter {5/ 05 t: 26A | 4) The red indicator light on the USB charging cable will turn off when the battery is charging, and will tum on when the battery s fully charged. 5) Charging time: about 90 minutes.
9.0 INSTALLATION 9.1 Propellers The drone wil not iy unless the correct propeller Is installed on the correct motor shaft. See illustration above. printed on the each propeller. Lock the propeller to the motor shaft with screw rotating each screw clockwise. 9.2 Drone Battery 3] Plebe Installation: Push the battery into the battery compartment at the rear of the drone. Make sre the battery is in place to ensure that the battery is Jammed in the battery compartment. {Pic.
9.3 Propeller Guard installation: Line up the protruding points on the propeller guard with the sunken grooves on the drone and insert them together. Tightly press both sides of the propeller guard into place after the sunken grooves and protruding paints have completely interlocked Removal: Lightly pull on the clip on ane of the ends of the propeller guard outwards until it has separated from the inside of the drone, at which point the propeller guard can be fully removed.
9.4 Transmitter Battery 3x15vAn Battery Cover (iAo As shown above, insert the battery into the battery compartment. Please pay attention to the positive and negative polarity of the battery to ensure the correct insinuation of the battery. 9.5 Phone Holder As shown above, pul the phone holder down and insert the fore.
10.0 OPERATION GUIDE 10.1 Download APP Android APP on Google play Scan the QR aced, corresponding to either App Store™ or Google Piay™ Store and download the DE FPV app for free. Required Operating Systems: iCS 9.0 or later / Android 5.1 o later 10.2 Connect to WI-Fi Connect your smart phone to the Wi network created by the drone. Check the drone's status in the DE FPV app.
example. 10.3 Pairing @ Press and hood the power button to wrn on the drone and the indicator eights on the drone begins to flash. @ Place the drone on a flat and level surface with the head forward and the tail towards the pilot ® Press the power button on the transmitter to tum it on and you wil hear “Di Di', then the indicator light on the transmitter will flash. @ Push the left joystick up then down to pair the drone with the transmitter.
10.4 Calibrating the Gyroscope Push the left and right joystick simultaneously to the dower left comer to calibrate the gyro. When the indicator lights on the drone change from flashing quickly to solid, It indicates that the calibration has been completed. Tips: To ensure 3 stable fight, we suggest that the pilot calibrates the e every time after parking the drone and after a crash. @ short press the One Key Takeoff/ Landing button the drone wil automatically take off and hover at 5 feet attitude.
11.0 FUNCTION DETAILS 11.1 Emergency Stop & me Emergency Stop function can be only used In case of emerge oy during the Right to veld ary of damage o In fury. Press and hold the Emergency Stop button for about 2 seconds, the motors will stop immediately. 11.2 Speed Switch This drone comes with 3 speed Revels {Low/ Medium High). Press the Speed Switch button on the transmitter to switch the speed. “Di° indicates Low Speed, “Di DI indicates Medium Speed and “Di Di Di* indicates High Speed.
