Operation Manual

This document and the information in it are provided in confidence, for the sole purpose of exploring business opportunities between the disclosing party and the
receiving party. Confidential document. It is not allowed to reproduce or disclose partial or totally the information contained in it, except by express written consent of
Deeptrack.
© DEEPTRACK | 2020
DPT-EG-MAN-DBR31-TECMAN-001-A3 Technical Manual
4. Installation instructions
4.1. Power the DBOARD
The DBOARD is powered through one SPT 2.5/4-V-5.0 connector in the left lower part of the board. 24VDC powered,
this power supply may come from an AC/DC converter, battery, DC/DC converter, etc.
Mostly of the power supply will work with the DBOARD, but the condensers in the input may be considered.
Regulated source between 5 - 30V on 24V with current limiting and short circuit protection.
When the DBOARD is powered, the PWR LED must be ON.
4.2. Program the DBOARD
Through the JT1 connector the firmware of the DBOARD should be loaded in the microcontroller
memory. The micro can access to the NFC EEPROM memory, where, as example, the user could write
the configurable parameters for commissioning the board.
Microcontroller MuRata model is CMWX1ZZABZ-078.
5. Commissioning procedure
The commissioning procedure may be carried out by writing in the NFC memory of the board. Then the firmware may
use this data stored in the memory to control and interact with the devices attached to the board.
To facilitate the commissioning, it is based on a smartphone application developed by DEEPTRACK. This application runs
in any android smartphone with NFC implemented. In case of a bad NFC implementation of the phone there can be
some difficulties to connect, so we recommend using one of the following devices that have been validated by the
application developers:
- Huawei Y8 2018
- Motorola G6
The commissioning consists on set the parameters in every DBOARD by writing them in its NFC memory. The
application also writes the radio and unique ID data automatically in the NFC memory.
6. DATA
6.1 Manufacturer data
DEEPTRACK, S.L.U.
C/ Avenida de la Transición Española, 32, Edificio A, Planta 4
28108 - ALCOBENDAS (Madrid) - ESPAÑA
CIF: B-85693224
Telephone: [phone]
6.2 Equipment data
Type of equipment
Single axis tracker controller.
Equipment name
DBOARD R3
Models
DBOARD R3
WARNING
The board should not be connected while the power supply is on.