User's Manual
Table Of Contents
- 1. Warning:
- 2. Charger Interface:
- 3. Display Diagram:
- 4. Function and Reset Buttons:
- 5. Power Supply:
- 6. Exploring the Simple Mode Interface of the Software
- 7. Add the Charger to Your WiFi Network, Using Your Laptop/PC
- 8. Add the Charger to Your WiFi Network, Using the WPS Method
- 9. Add a Charger and Set-Up.
5. POWER SUPPLY:
The MegaCell Charger requires a 5
volts power supply to be powered.
For the current, we recommend at
least 18 Amps. Is recommended
using 4mm cross sectional copper
wire for the connection between
PSU and Megacellcharger.
Please make sure that the power
supply is providing 5V. MegaCell
Charger requires the voltage to be
always +5V, but not higher than
5,6V. after the cables are connected to the charger, you’re ready to power your MegaCell
Charger.
MEGACELL CHARGER 6