User's Manual
Table Of Contents
- 1. Warning:
- 2. Charger Interface:
- 3. Display Diagram:
- 4. Function and Reset Buttons:
- 5. Power Supply:
- 6. Exploring the Simple Mode Interface of the Software
- 7. Add the Charger to Your WiFi Network, Using Your Laptop/PC
- 8. Add the Charger to Your WiFi Network, Using the WPS Method
- 9. Add a Charger and Set-Up.
3. DISPLAY DIAGRAM:
4. FUNCTION AND RESET BUTTONS:
Pressing shortly on the functions button will cycle display info for each cell.
Holding down the functions button for more than 2 seconds will cycle through the menu options:
1. Start mCap: Starts the Measure Capacity function
2. Stop mCap: Stops the Measure Capacity function
3. Start Charge: start charging the cells
4. Stop Charge: stop charging the cells
5. Start Discharge: start discharging the cells
6. Stop Discharge: stop discharge the cells
7. IP Information: Shows the charger IP from your network if device is connected
8. Self Test: Starts the self-test for debugging (make sure no cells are inserted in the charger)
9. Factory Reset: Deletes all the settings and returns to the default factory settings
10. Firmware V: Shows the firmware version currently installed
11. Store Charge: Starts the store charge
12. Stop Store Charge: Stops the store charge
13. Exit Push Menu
The reset button, restarts the charger operating system, measuring data is lost and process must
restart.
MEGACELL CHARGER 5