User's Manual
Table Of Contents
- 1. Warning:
- 2. Charger Interface:
- 3. Display Diagram:
- 4. Function and Reset Buttons:
- 5. Power Supply:
- 6. Exploring the Simple Mode Interface of the Software
- 7. Add the Charger to Your WiFi Network, Using Your Laptop/PC
- 8. Add the Charger to Your WiFi Network, Using the WPS Method
- 9. Add a Charger and Set-Up.
8. ADD THE CHARGER TO
YOUR WIFI NETWORK, USING
THE WPS METHOD
You can connect your device through
your router using the WPS Method.
If there’s no saved WiFi info, or the old
connection is not available, the charger
will try to connect first through WPS.
Most routers have a button, which will
allow the charger to connect without
having to type in the password. Keep
that button pressed a few seconds,
until the router enters in the WPS
mode.
The connected message and the IP address should appear on the display in a few seconds
after the WPS has been activated on your router, and the MegaCell Charger completed the
connection.
MEGACELL CHARGER 12