User's Manual
Table Of Contents
- 1. Warning:
- 2. Charger Interface:
- 3. Display Diagram:
- 4. Function and Reset Buttons:
- 5. Power Supply:
- 6. Exploring the Simple Mode Interface of the Software
- 7. Add the Charger to Your WiFi Network, Using Your Laptop/PC
- 8. Add the Charger to Your WiFi Network, Using the WPS Method
- 9. Add a Charger and Set-Up.
The blue button is for measuring the capacity.
The green button with a box icon will get the cells to the store voltage.
The red button will stop any operation.
The pink button will stop any operation.
The brown button will stop any operation.
The purple button will stop any operation.
This button will stop any operation.
7. ADD THE CHARGER TO
YOUR WIFI NETWORK, USING
YOUR LAPTOP/PC
First connect with your laptop to the
WiFi access point that MegaCell
Charger creates when there’s no WiFi
Connection set, or if the old connection
is not available.
You will see
Start conf
portal on the
display. The
access point
name and the password is also shown on the display.
MEGACELL CHARGER 10