User's Manual

Operation
52 Operation
UV processing mapped location
You can use this feature to disinfect mapped locations. The robot disinfects the paths desi
gnated on the map.
1 Move the robot to the UV processing tar
get space. (See page 17.)
2 Remove the UV-C lamp protection covers fro
m the robot. (See page 17.)
3 Turn on the robot.
4
4 Touch the screen on the robot.
An OTP number for registering the robot on
your mobile device will appear.
5 Enter the OTP number on the mobile device
where the control app is installed. Once the
robot is registered on the mobile device, a s
creen will appear for you to set the UV proc
essing target space.
,
Note
y Press [Skip] to proceed to UV processing wit
hout registering the robot on the mobile d
evice.