User's Manual

P.6
7）
Mode 7: All of the motors increase or reduce
g
raduall
y
to
g
ether.When increased to the stron
g
est
,
all motors will decrease a
gyg g,
bit and increase again. This format repeats twice. T
hen all the motors gradually decreased to a minimum. So the repeated
work. The default intensity and speed are in normal status. You can press the "INTENSITY" and "SPEED" buttons to change
the motor's intensity and speed.
8）
Mode 8: First, motor 1 increases gradually. When it reaches the strongest, it begins to reduce and at the same time, motor 2
starts and increases gradually. When motor 2 reaches the strongest, motor 1 stops. At the same time, motor 3 starts and
increases gradually. T
his format happens to motor 4 and 5, finally back to motor 1 again. All motors are gradually increased
or gradually reduced. The default intensity and speed are in normal status. You can press the "INTENSITY" and "SPEED"
buttons to change the motor's intensity and speed.
9）
Mode 9: First, motor 1 increases gradually. When it reaches the strongest, it begins to reduce and at the same time, motor 2
starts and increases gradually. When motor 2 reaches the strongest, motor 1 stops for a while . Then, motor 1 and 3 start
and increase gradually. When motor 1 and 3 reach their strongest, motor 2 stops for a while. Then motor 2 and 4 start and
increase gradually. When motor 2 and 4 reach the strongest, motor 1 stops. Then motor 3 and 5 start and increase
gradually. When motor 3 and 5 reach the strongest, motor 4 only starts and increases gradually and decreases. After motor
2016/2/23
00
CUST
OMER'S MODEL NO.:
NIL
VERSION : G
CUSTOMER'S PART NO. :
P-0508-DV
DATE :
Deeling(HK)TechnologyCo.,Ltd
Any Changes or modifications not ex pressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
( 1 ) This device may not cause harmful interference, and
( 2 ) This device must accept any interference received, including interference that may cause undesired
operation.
Controller P-0510-CT User Manual
5 works, all motors stop then start from the beginning.The default intensity and speed are in normal status. You can press
the "INTENSITY" and "SPEED" buttons to change the motor's intensity and speed.
This Product is equipped with bluetooth function.When the controller is powered on,the Bluetooth will automaticallly turn
on.The mobile phone can connect the Bluetooth to control the vibration motors kit.
F
CC Statement
RF warning :
The device complies with FCC exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter .