User guide

2010 - Current Driver Side Rear Brace (continued)
Put the 8mm bolt [X] through the 8mm washer [Y] and a bent spacer [W], then put the bolt through
the slot in the brace, and through another bent spacer [W] on the top of the brace. Thread the 8mm
bolt into the weld nut on the sub-floor support.
Tighten the factory bolt using an 18mm socket. Tighten the 8mm bolt using a 13mm wrench or socket.
FX 12958 14 OF 17 6/1/2011