INSTALLATION INSTRUCTIONS BOLT-ON BED RAIL
BOLT-ON BED RAIL PARTS LIST: 2 Bed Rails 4 80mm Rectangular Threaded Brackets 4 50mm Parallelogram Threaded Bracket 1 Allen Wrench 4 10-1.50mm x 50mm Allen Head Bolts 4 10mm ID x 20mm OD x 1.5mm Stainless Steel Flat Washers PROCEDURE: 1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. CUTTING MAY BE REQUIRED. VERIFY BEDRAIL IS CORRECT LENGTH TO COVER STAKE POCKETS BEFORE CUTTING! 2.
BOLT-ON BED RAIL Remove cover if equipped. Note, on some vehicles, size of opening in cover may be larger than actual stake pocket Fig 1 Dotted line represents approximate size of stake pocket hidden under plastic cover Determine location of center of stake pocket before cutting cover. Start with a small hole and gradually enlarge the hole to the size of the stake pocket only. Do not follow lines molded into cover! Note that size of stake pocket may be smaller than line molded into cover by factory.
BOLT-ON BED RAIL Small Stake Pocket Pictured Oversized Stake Pocket Pictured Engage one side first Fig 4A Fig 4B Small Stake Pocket Pictured Fig 5A Oversized Stake Pocket Pictured Fig 5B Pull up on Bedrail as you tighten the mounting screw to hold the threaded plate in place against inside of stake pocket Complete Installation Page 3 of 3 1/20/11 Rev1(DP)
