Manual

5-Drawer Tool Box

Instr uctions

Included Parts: Five-drawer tool box including one door with

lock, ve drawers, one bottom mounting tray, mounting hard-

ware (6 bolts, 6 washers, 6 nuts), 2 keys.

Required Tools: 3/8” drill bit, 1/2” wrench.

Caution: Beware of any sharpe edges or rivets!!!

PAGE 1
5-Drawer Tool Box Instructions Caution: Beware of any sharpe edges or rivets!!! Included Parts: Five-drawer tool box including one door with lock, five drawers, one bottom mounting tray, mounting hardware (6 bolts, 6 washers, 6 nuts), 2 keys. Required Tools: 3/8” drill bit, 1/2” wrench.
PAGE 2
1. Open front door and remove bottom drawer to access the locking tab at on the body floor. This tab will allow you to release the mounting tray from the tool box. 2. While pressing the 2 latch posts on the inside of the box together, push the bottom tray towards the back of the box. This will result in the separation of the mounting tray from main body housing, leaving 2 separate parts.
PAGE 3
. Position the mounting tray behind the fender flare of your choice, ensuring to have the front facing the tailgate. 4. When you have the mounting tray in the desired position, it is recommended to mark the holes prior to drilling in case shifting of the mounting tray occurs during drilling. 5. Using a 3/8” bit, drill through the bed exterior on your markings. 6. Thoroughly clean the surface location where the tool box will be mounted, then line up the drill holes to the mounting tray. 7.