(W) INSTALLATION INSTRUCTIONS GRILLE GUARD 07-12 TOYOTA TUNDRA / 08-12 SEQUOIA PART # 501894 & 501895
GRILLE GUARD 07-12 TOYOTA TUNDRA / 08-12 SEQUOIA PARTS LIST: 1 Grille Guard 4 3/8" Flat Washers 1 Driver/Left Frame Mounting Bracket 2 3/8" Nylon Lock Nuts 1 Passenger/Right Frame Mounting Bracket 4 12mm Plastic Washers 1 Driver/Left Top Top Mounting Bracket 4 12-1.75mm x 35mm Hex Bolts 1 Passenger/Right Top Mounting Bracket 4 12mm Lock Washers 1 Driver/Left Top Bracket 4 12mm ID x 32mm OD x 3mm Flat Washers 1 Passenger/Right Top Bracket 4 10-1.
GRILLE GUARD 07-12 TOYOTA TUNDRA / 08-12 SEQUOIA 6. Open the hood and locate the two factory holes facing forward on the driver side of the bottom radiator core support cross member. Insert (1) Double Bolt Plate in from the back of the radiator core support and out the front through the (2) holes, (Figure 2). 7. Locate the driver side Top Mounting Bracket and move it into position, (Figure 3). NOTE: Tab with welded hex nuts on the Top Mounting Bracket should point down, (Figure 6).
GRILLE GUARD 07-12 TOYOTA TUNDRA / 08-12 SEQUOIA Driver/Left Side Installation Pictured Frame Mounting Bracket installed with small factory tow hook and hardware Fig 1A The heavy duty factory tow hooks cannot be reinstalled and will not clear the Frame Mounting Brackets Front Insert Double Bolt Plate through the back of radiator core support cross member Fig 1B Top Mounting Bracket Double Bolt Plate Front (Fig 2) Viewed from above (1) Double Bolt Plate (2) 10mm Nylon Lock Nuts (2) 10mm Flat Washers
GRILLE GUARD 07-12 TOYOTA TUNDRA / 08-12 SEQUOIA Driver/Left Side Installation Pictured 10mm x 35mm Hex Bolts 10mm Lock Washers 10mm Flat Washers Front Top Bracket Top Bracket Fig 5 Pull the Top Bracket as the hardware is tightened to provide maximum clearance between Grille Guard and vehicle Fig 6 07-On Sequoia Pictured Fig 7 Fig 8 (2) 3/8 Plastic Washers (1) 3/8" Flat Washer (1) 3/8 Nylock Nut (Fig 9) Insert a Plastic Washer between the Grille Guard and the Top Bracket and under the Flat Washer
GRILLE GUARD 07-12 TOYOTA TUNDRA / 08-12 SEQUOIA Driver/Left Side Installation Pictured Loosen the top bolts (only if necessary) to open the hood Pull Grille Guard to the "open" position Fig 11 Fig 12 Front Push Grille Guard back to the "closed" position Fig 13 Quick Release in "closed" position Fig 14 Front Opening and closing the hood 17. Rotate the lever on the Quick Release bolt to release the clamping pressure, (Figure 10). Pull the Grille Guard to the "open" position, (Figure 11).
