(W) INSTALLATION INSTRUCTIONS SIDEBAR TOYOTA TUNDRA REGCAB/ DOUBLE CAB 07-13 PART # DZ 372811/DZ 372813/DZ 372831/DZ 372833
SIDE BAR TOYOTA TUNDRA REGCAB/DOUBLE CAB 07-13 PARTS LIST: 1 1 1 1 1 1 2 Driver/Left Sidebar Passenger/Right Sidebar Driver/Left Front Mounting Bracket Driver/Let Rear Mounting Bracket Passenger/Right Front Mounting Bracket Passenger/Right Rear Mounting Bracket 10mm x 30mm Bolt Plates 4 4 4 8 2 2 10 12 2 2 2 ½” x 2” Hex Head Bolts ½” Lock Washers ½” ID x 1-1/2” OD x 1/8” Flat Washers 8-1.25mm x 35mm Hex Head Bolts 8-1.
SIDE BAR TOYOTA TUNDRA REGCAB/DOUBLE CAB 07-13 PROCEDURE: 1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. DRILLING REQUIRED 2. Starting on the driver side front of the vehicle, locate the two factory threaded holes and a factory round hole in the side panel (Figure 1). NOTE: You need to remove plastic plug to uncover the round hole. 3. Insert one of the 10mm x 30mm Bolt Plate into factory round hole (Figure 2).
SIDE BAR TOYOTA TUNDRA REGCAB/DOUBLE CAB 07-13 (Driver Side Installation Shown) 10mm Bolt Plate Fig 1 Fig 2 Fig 3 Tundra Rear Mounting Location Sequoia Rear Mounting Location Fig 4 Page 3 of 5 Fig 5
SIDE BAR TOYOTA TUNDRA REGCAB/DOUBLE CAB 07-13 Fig 6 Fig 7 Fig 8 Fig 9 Page 4 of 5
SIDE BAR TOYOTA TUNDRA REGCAB/DOUBLE CAB 07-13 8mm x 25mm Hex Bolt 8mm Lock Washer 8mm Flat Washer 8mm Hex Nut Fig 10 Fig 12 Fig 11 Fig 13 ½” x 2” Hex Head Bolts ½” Lock Washers ½” Flat Washers Sequoia Installation Complete Fig 14 Page 5 of 5 Tundra Installation Complete Fig 15
