INSTALLATION INSTRUCTIONS 3"/4" BENT END SIDEBARS 09-12 FORD F-150 REGULAR AND SUPERCAB PART # DZ 372297/ DZ 372299/DZ 372337 Regular Cab complete installation
3"/4" BENT END SIDEBARS 09-11 FORD F-150 REGULAR AND SUPERCAB PARTS LIST: 1 1 1 1 2 1 1 1 1 2 2 4 2 4 4 Driver/Left Sidebar Passenger/Right Sidebar Driver/Left Front Mounting Bracket Passenger/Right Front Mounting Bracket Support Brackets Driver/Left Top Mounting Bracket Passenger/Right Top Mounting Bracket Driver/Left Rear Mounting Bracket Passenger/Right Rear Mounting Bracket 12mm x 40mm x 10mm Nut and Bolt Plate 12mm x 40mm Bolt Plates 12mm Plastic Retainers 10mm Plastic Retainers 1/2" x 2” Hex Bolts 1/
"/4" BENT END SIDEBARS 09-11 FORD F-150 REGULAR AND SUPERCAB 3. Select the driver side front Mounting Bracket. Line up the (2) holes in the pinch weld with the holes in the front Mounting Bracket. Insert (2) 8mm x 30mm Hex Bolts with (2) 8mm x 24mm OD x 2mm Large Flat Washers up from below and secure with (2) 8mm x 16mm OD x 1.6mm Small Flat Washers, (to clear the bracket), (2) 8mm Lock Washers and (2) 8mm Hex Nuts, (Figure 2). Do not tighten hardware at this time. 4.
3"/4" BENT END SIDEBARS 09-11 FORD F-150 REGULAR AND SUPERCAB For gloss black finishes: Mild soap may be used to clean the Sidebar. Driver Side Installation Pictured (2) 8mm x 30mm Hex Bolts (2) 8mm Lock Washers (2) 8mm x 24mm Large Flat Washers (outer) (2) 8mm x 16mm Small Flat Washers (inner against Bracket) (2) 8mm Hex Nuts Fig 1B Front Fig 1A Front Remove these two hex bolts and metal clip nuts.
3"/4" BENT END SIDEBARS 09-11 FORD F-150 REGULAR AND SUPERCAB Driver Side Installation Pictured Front (1) 10mm x 35mm Hex Bolt (2) 10mm Large Small Washers (1) 10mm Lock Washer (1) 10mm Hex Nut Fig 7A Fig 6 Rear Rear Fig 7B Fig 8A 12mm Bolt Plate 12mm Plastic Retainer 12mm Flat Washer 12mm Lock Washer 12mm Hex Nut 10mm x 35mm Hex Bolt 10mm Plastic Retainer (2) 10mm Flat Washers 10mm Lock Washer 10mm Hex Nut (Fig 8B) Rear bolt on Rear Mounting Bracket pictured from outside of vehicle.
3"/4" BENT END SIDEBARS 09-11 FORD F-150 REGULAR AND SUPERCAB 12mm Bolt Plate with Plastic Retainer 12mm Flat Washer 12mm Lock Washer 12mm Hex Nut Fig 7 Rear Fig 6 Regular Cab rear mounting location pictured. Thread the Plastic Retainer onto the Bolt Plate then insert the Bolt Plate into the large hole in the body.
