(W) INSTALLATION INSTRUCTIONS 3," 4" ROUND AND 4" OVAL BENT END SIDEBAR FORD F250/350/450/550HD SUPER DUTY REG.
90-DEGREE BENT END SIDEBAR 99-12 FORD F-250/450 SUPERDUTY REG, SUPER AND SUPER CREW CABS PARTS LIST: 1 1 2 2 2 4 4 Passenger Sidebar Driver Sidebar Driver Side Front/Passenger Side Rear Mounting Brackets Driver Side Rear/Passenger Side Front Mounting Brackets Front Bracket Spacers 1/2" x 2" Hex Bolts 1/2" Lock Washers Driver/Left Rear Mounting Bracket 4 6 14 22 14 8 1/2 x 1-1/2" OD x 1/8" Flat Washers 10mm Clip Nuts 10-1.
90-DEGREE BENT END SIDEBAR 99-12 FORD F-250/450 SUPERDUTY REG, SUPER AND SUPER CREW CABS To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be used also to clean the Sidebar.
90-DEGREE BENT END SIDEBAR 99-12 FORD F-250/450 SUPERDUTY REG, SUPER AND SUPER CREW CABS Driver Side Installation Pictured 10mm Clip Nut 10mm x 40mm Hex Bolt 10mm Lock Washer 10mm Flat Washer Disregard extra slot on front bracket installation Line up Clip Nuts with factory holes Front Fig 5 (2) 10mm x 40mm Hex Bolts (2) 10mm Lock Washers (4) 10mm Flat Washers (2) 10mm Nuts Rear Line up 10mm Clip Nut with factory holes (Fig 6) Example of typical rear mounting location (2) Clip Nuts (2) 10mm x 40mm H
