User guide

Place the aluminum plates on the outside of the braces that are attached to the vehicle.
Attach the board to the braces using the 3/8" hex head bolts [F], flat washers [G], lock washers [H], and
nuts [I].
Do not completely tighten at this time.
6
5
Using a 13mm wrench/socket, tighten the bolts attaching the brace to the vehicle.
Using a 9/16" wrench/socket, tighten the carriage bolts attaching the aluminum plates to the board.
Using a 9/16" wrench/socket, tighten the bolts installed in step 6.
Make sure all bolts are tightened. Repeat steps for other side.
DZ 15 6 of 6 4/25/2012